Honda 21 Commercial

Discussion in 'Mechanic and Repair' started by siclmn, Jun 29, 2002.

  1. siclmn

    siclmn LawnSite Senior Member
    Posts: 364

    I am replacing a pin that broke so the driveshaft would not turn. The splines on the end of the shaft were bone dry. Should I grease them or is there so much dirt in that area that you don''t grease at all.
  2. grasmo

    grasmo LawnSite Member
    from fl
    Posts: 34

    if it is not a sealed area you should never put any fluid type lubricant in a place of dirty enviroment. you end up with lapping compound.

Share This Page