1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

how do you bleed the mower

Discussion in 'Mechanic and Repair' started by captain henry45, Oct 6, 2009.

  1. captain henry45

    captain henry45 LawnSite Member
    Posts: 3

    I have a 52"lesco walk behind and i need to find out how to bleed the hydaulic system after you change the fluid or if you even need to
     
  2. topsites

    topsites LawnSite Fanatic
    Posts: 21,654

    You shouldn't have to, but take it easy at first and see how it all works.
     
  3. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    ??????


    Always fill the new filter(s) with oil before installing, Once the system is re-filled raise and block the drive wheels off the ground. Start the engine and run about 3/4 throttle, Move the controls full forward then full reverse slowly 8 to 10 times then re-check fluid level.

    Set it back on the ground and go mow......
     

Share This Page