How much do you angle paver's without cutting?

Discussion in 'Hardscaping' started by 4 seasons lawn&land, May 3, 2009.

  1. 4 seasons lawn&land

    4 seasons lawn&land LawnSite Gold Member
    from NY
    Posts: 3,594

    to make a turn.
     
  2. soopa

    soopa LawnSite Member
    from NY
    Posts: 135

    you mean how wide will you open your joint? < 1/2"
     
  3. 4 seasons lawn&land

    4 seasons lawn&land LawnSite Gold Member
    from NY
    Posts: 3,594

    yeah, if your making a turn with a side walk you would open the gap up to 1/2 inch before you have to make an angle cut?
     
  4. mrusk

    mrusk LawnSite Gold Member
    Posts: 3,260

    1/8th. Anymore then 1/4 and you are a hack.
     
  5. 4 seasons lawn&land

    4 seasons lawn&land LawnSite Gold Member
    from NY
    Posts: 3,594

    hear that soop? your a hack...:drinkup:
     
  6. NewHorizon's Land

    NewHorizon's Land LawnSite Senior Member
    Posts: 690

    A 1/4 inch is hard to cut off considering the diamond blades are a 1/4 inch mostly.

    Up to 1/2"
     
  7. soopa

    soopa LawnSite Member
    from NY
    Posts: 135

    guess so :rolleyes:
     
  8. ZX12R

    ZX12R LawnSite Senior Member
    Posts: 785

    "hear that soop? your a hack... "


    You guys are hilarious!:):)
     
  9. Rex Mann

    Rex Mann LawnSite Senior Member
    Posts: 621

  10. soopa

    soopa LawnSite Member
    from NY
    Posts: 135

    Rex, where did you find his spec?

    AFAIK the only language ICPI has on the issue is "no v-shaped joints" period. ICPI recommends cutting EVERY other block on a curve or radius to maintain straight 2 - 5mm joints. Not realistic, IMO.
     

Share This Page