How to lower sprinkler heads

Discussion in 'Irrigation' started by PACLandscape, May 22, 2004.

  1. PACLandscape

    PACLandscape LawnSite Member
    Posts: 3

    I have a commercial client that has a irrigation system in the planters out in front of their establishment. There are seven heads that need to be lowered because the planters height is being lowered. How difficult is it to lower these heads. They have to be lowered 12''.

    PAC
     
  2. greenworldh20

    greenworldh20 LawnSite Senior Member
    Posts: 659

    you sub it out to a qualified irrigation contractor...

    not hard at all.

    b--
     
  3. Grassmechanic

    Grassmechanic LawnSite Silver Member
    Posts: 2,697

    piece of cake if they are on a swing joint.
     
  4. D Felix

    D Felix LawnSite Bronze Member
    Posts: 1,898

    Where is the zone line in relation to the heads? Is it well below where the heads need to be?

    I don't do irrigation work, but I know enough that I could do that job if the zone line was low enough. If it needed to be lowered, I'd be calling our sub........


    Dan
     
  5. Merc145

    Merc145 LawnSite Member
    from Texas
    Posts: 16

    Since noone has given an easy answer. I will. Try and find out if the risers are screwed on. If so get a shorter riser, use flex or funny pipe. It is easy as that. Hope it helps.
     

Share This Page