1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

how to maint a chain saw

Discussion in 'Lawn Mowing' started by cmurphy128, Mar 14, 2004.

  1. cmurphy128

    cmurphy128 LawnSite Member
    Posts: 41

    Daily routines
    •Check the throttle trigger for smooth operation. If any binding occurs, or if engine fails to return to idle, the saw should be taken to your dealer, before it is used again. Also, be sure that the trigger cannot be pulled until the throttle trigger lockout is depressed. •Clean the chain brake and check its function according to the instructions. Make sure that the chain catcher is undamaged. Otherwise replace it immediately. •Clean or replace the air filter as necessary. Check for damage or holes. •The bar should be turned daily for more even wear. Check the lubrication hole in the bar, to be sure it is not clogged. Clean the bar groove, if the bar has a sprocket tip, this should be lubricated. •Check the function of the oiler to be sure the bar and chain receive proper lubrication. •Sharpen the chain and check its tension and condition. Check the drive sprocket for wear. Replace if necessary. •Check the starter and starter cord for wear or damage. lean the air intake slots on the starter housing. •Check for any loose nuts and screws and retighten if necessary. •Test the stop switch to be sure it shuts off the engine. •Check the cooling system of saw fitted with catalytic converter.

    Weekly routines
    •Check that the AV elements are not soft or torn. •Lubricate the clutch drum bearing. •File off burrs, if any, on the sides of the bar. •Clean the spark plug and check the gap. The correct gap is 0,5 mm (0,020 inch). •Check the starter and the recoil spring. Clean the fins on the flywheel. Clean the cooling fins on the cylinder. •Clean or change the screen in the muffler. •Clean the carburetor body and air box.

    Monthly routines
    •Check the brake band on the chain brake for wear. •Check the clutch centre, clutch drum and clutch spring for wear. •Clean the outside of the carburetor. •Check the fuel filter. Change if necessary. •Clean the inside of the fuel tank. •Clean the inside of the oil tank. •Check all cables and connections.

Share This Page