1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

How to replace drive belt on older Lazer

Discussion in 'Lawn Mowing' started by eXme, Apr 24, 2010.

  1. eXme

    eXme LawnSite Member
    Posts: 22

    Have a model #LZ25KC604 Serial#220621 which is a 2001 I believe. My question is how to get the belt over the clutch to attach to the pulley. It looks like you can just take out the bolts/nuts that are attached to the clutch with steel wire (limiters?) then attach the belt and replace bolts but I wanted to ask some of you guys first. I blew this one out a couple of years ago and the shop replaced it for me but am hoping to finish a job tomorrow so I would like to know how to do it myself in case it happens while on a job again.

  2. lasher66

    lasher66 LawnSite Senior Member
    Posts: 395

    Pretty much what you said. Undo the wire going to the clutch if its limiting the belt from coming off, the loosen the nut the holds the limiter from allowing the clutch to spin. You only have to loosen it, then it should swing out and allow you to take belt off.

  3. eXme

    eXme LawnSite Member
    Posts: 22

    Thanks, so do you loosen the nut attached to the frame or attached to the clutch?
  4. eXme

    eXme LawnSite Member
    Posts: 22

    Ok , it's on now. Gonna need to keep 9/16 handy in future.

Share This Page