Hunter module faulty l think?

Discussion in 'Irrigation' started by duckworth, Jun 21, 2012.

  1. duckworth

    duckworth LawnSite Member
    Posts: 149

    Replaced older RB clock with a PRO C 15 station.station 1-3 ran great, station 4 to 14 clock says it's watering but it's not?when l drop any of the upper station wires to zone 3 they work. Is there something simple I'm missing is it possible a brand new 3 and 9 zone module showed up faulty.
     
  2. 1idejim

    1idejim LawnSite Fanatic
    Posts: 9,313

    Have you pulled and reseated the mod? they can be locked in place without being seated properly. i have done it.
    Posted via Mobile Device
     
  3. avernon0112

    avernon0112 LawnSite Member
    Posts: 126

    Did those zones function with the old controller? Could be the common.
     
  4. 1idejim

    1idejim LawnSite Fanatic
    Posts: 9,313

    he said all valves worked when connected to zone 3.
    i have removed mods to access or measure other wires and not gotten the mod in and had to reseat the modual before the zones fired
    Posted via Mobile Device
     
  5. avernon0112

    avernon0112 LawnSite Member
    Posts: 126

    I read that one a little to fast.
     
  6. duckworth

    duckworth LawnSite Member
    Posts: 149

    The mods came installed in clock l removed and pushed back in and they seemed to click in nicely.but still no water.does the power/lock switch have to be in the off position when you push in module in and then flip power/lock switch on?
     
  7. jvanvliet

    jvanvliet LawnSite Gold Member
    Posts: 3,939

    Yes, unlock to remove, and then on once seated.
     
  8. Duekster

    Duekster LawnSite Fanatic
    from DFW, TX
    Posts: 7,961

    The odd part is it shows to be watering. IIRCC most mod controllers do not allow you to program stations if it does not see the Mod. I would go get a new mod.
     
  9. duckworth

    duckworth LawnSite Member
    Posts: 149

    Tryed good module and front panel from my own board and still says water working but no water.So l took the new circuit board out and compared it to my circuit board that's when l found problem. The new board had only one brass contact underneath ,my good working board had 4 brass contacts one for each module slot. Switched boards and got my customers system working:).6 hrs wasted in travel ph.calls and unnecessary labour :hammerhead:.on top of it my supplier giving me additude and a new clock:)l will try and show you photos if I can figure out to get it from iPhone to here
     
  10. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 21,896

    I've had that happen, not only from suppliers, but from REPS, as well. It's important to remind the clean shoe boys, "YOU WORK FOR ME". :hammerhead:
     

Share This Page