Husqvarna HYDRO problems

Discussion in 'Mechanic and Repair' started by jlbf0786, Apr 15, 2010.

  1. jlbf0786

    jlbf0786 LawnSite Senior Member
    Male, from Charlotte, NC
    Posts: 520

    I'm having trouble adjusting the HYDRO pump's on my Husqvarna walkbehind.

    The left wheel wont stop turning completely, no matter how far i turn the hydro-pump.. i unscrewed it so far that the hydro fluid shot out of the pump itself.. and it went everywhere! but even then, the wheel was still turning!

    Can anyone give me any insight on this?

    thanks
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    Raise the wheels off the ground and block it up, Start the engine and make your adjustment with the control lever linkage going to the pump not with anything on the pump it's self. Adjust until the wheel stops creeping.
     
  3. jlbf0786

    jlbf0786 LawnSite Senior Member
    Male, from Charlotte, NC
    Posts: 520

    --- man you have the answer to "literally" everything! ---
    Thanks again, for your help
     
  4. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    [​IMG]
     

Share This Page