Hustler Super Mini Z Deck Problem Help

Discussion in 'Lawn Mowing' started by SuperFast, Apr 27, 2005.

  1. SuperFast

    SuperFast LawnSite Member
    from Tenn
    Posts: 45

    :help: I just got a Super mini z 52" 25hp kaw have been mowing with it for a while now and i am not able to stripe a yard because i have to keep over lapping. The discharge leaves a little bit of uncut grass and does not want to discharge properly and I'm getting sick of it :angry: I have bought the new blades and also had my dealer cut out the 1inch on top and 3inch on the bottom of the discharge area and still get the same problem i hated to spend 8,100dollars on the unit it to start with and i thought i was making a good investment but i see other cutters
    running circles around me with there mowers is it possible that the discharge is still to small. what should i do it only has 25hours on the mower. and also will it cost me to fix the mower when you have found the problem Thanks
     
  2. scagboy227

    scagboy227 LawnSite Member
    Posts: 151

    i say take a flamethrower and burn that mother up lol :D
     
  3. SuperFast

    SuperFast LawnSite Member
    from Tenn
    Posts: 45

    Thanks for the reply might as well hope they can fix it.
     
  4. scagboy227

    scagboy227 LawnSite Member
    Posts: 151

    lol where in tn do you live?
     
  5. SuperFast

    SuperFast LawnSite Member
    from Tenn
    Posts: 45

    Smyrna had to go to merf to get the mower though
     
  6. SuperFast

    SuperFast LawnSite Member
    from Tenn
    Posts: 45

    Does anyone know what might help me. Anything at all would help Thanks.
     
  7. flesh

    flesh LawnSite Member
    from ohio
    Posts: 77

    double blades
     
  8. SuperFast

    SuperFast LawnSite Member
    from Tenn
    Posts: 45

    Anyone have pictures of double blades on a hustler super mini z or can someone explain how to. Thanks
     
  9. sawman65

    sawman65 LawnSite Senior Member
    Posts: 751

    you need to take it back to the dealer to get it fixed.i have sold many of these mowers and have not run into any of those problems but here is some things to look for
    1 set the top no load rpm
    2 make sure the belt tenison is right
    those are the main things to look at hope thids helps
    that mower will run away from a scag and leave a better cut
    wile doing in
     
  10. Tider6972

    Tider6972 LawnSite Senior Member
    from Alabama
    Posts: 649

    What blades have you put on it?

    Go back to stock blades if you've changed.

    The Hustler deck modifications * Did Not Apply to the MiniZ *, only to full size Zs. Idoubt you have hurt anything by enlarging the opening, except that a Hustler mulch kit will no longer fit, neither will a Hustler bagger.

    Go to the Hustler forum and tell mowerconsultant your story, he will try to help I'm sure.

    Good luck !
     

Share This Page