Hydro. problem

Discussion in '<a href=http://www.plowsite.com target=_blank ?>Sn' started by UNCLE BOB, Jan 21, 2001.

  1. UNCLE BOB

    UNCLE BOB LawnSite Member
    Posts: 99

    I used my plow this morning-no problem. went home put in all new bolts "lift arm,top-bottom pump"etc. drive to carwash,on the way my plow starts dropping slowly. if left up for 45sec. it will be on the ground.I've NEVER had this kind of problem. can someone tell me what's going on please?I know you guys are going to tear me a new one,but it came with the truck. It's a meyers E-47! IF YOU CAN LOOK PAST THAT FACT PLEASE help me!!!! I'm lost
     
  2. GeoffDiamond

    GeoffDiamond LawnSite Bronze Member
    from Maine
    Posts: 1,651

    Sounds like you may have a problem with your inner or outer seals in your E-47 Power Unit.

    Geoff
     
  3. guntruck

    guntruck LawnSite Senior Member
    Posts: 527

    Yep i agree with Geoff, seems you have a leak somehwere thats causing the cylinder to drop. Check it out and let us know.
     
  4. finnegan

    finnegan LawnSite Member
    Posts: 109

    uncle bob, here to help, If the blade drops straight down it's the "a" valve on the back side of the unit take it out and check the o rings...

    If the blade drops and angles check your b valve,which is the one in front(red wire)make sure its clean and moves freely...

    if this doesn't help dissassemble the lift ram and check te piston assembly....
    good luck...
     

Share This Page