hydro service

Discussion in 'eXmark' started by LAZERMAN, Jan 14, 2002.

  1. LAZERMAN

    LAZERMAN LawnSite Member
    Posts: 19

    YOUR QUESTION ABOUT CHANGING THE HYDRO OIL IN YOUR EXMARK, WE WERE TOLD AT A FACTOR SCHOOL THAT ALL YOU HAVE TO DO IS CHANGE THE FILTER AND FILL IT BACK UP TO THE FULL LEVEL. THE ONLY TIME YOU NEED TO DRAIN THE MOBILE 15/50 IS IF YOU HAVE A PUMP OR WHEEL MOTOR GO OUT. GOOD LUCK AND ENJOY YOUR EXMARK.
     
  2. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    LazerMan,

    Your information is correct. I would like to add however that you should pre-fill the hydro filter to prevent excessive air from entering the hydro drive system.

    Also your statement "you don't need to drain the pumps and wheel motors unless one of them goes bad" is correct. When you remove the hydro filter the reservoir will drain and that is all the fluid you will need to remove and replace.

    Thanks

    Terry
     

Share This Page