1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

I Need Help!!

Discussion in 'Mechanic and Repair' started by Signature Landscaping1, Mar 4, 2006.

  1. Signature Landscaping1

    Signature Landscaping1 LawnSite Bronze Member
    from Mass
    Posts: 1,497

    In december i bought a brand new lesco w/b, it came with the catcher, but i need help putting the plate on for it, its a steel catcher. Can anyone tell or show me how to mount it. Thanks
    Joe
     
  2. Signature Landscaping1

    Signature Landscaping1 LawnSite Bronze Member
    from Mass
    Posts: 1,497

    fast, spring cleanups are starting soon
    thanks
     
  3. jsbmaine

    jsbmaine LawnSite Member
    Posts: 102

    If nobody else has an answer give me a call and I will try to figure it out with you. Take a couple pics and post them. i would think it's fairly easy, unless they require it to be welded. i think the mounts on the bunton are welded, but not too sure.
     
  4. Signature Landscaping1

    Signature Landscaping1 LawnSite Bronze Member
    from Mass
    Posts: 1,497

    alright ill take some pics today
     
  5. lawnmaniac883

    lawnmaniac883 LawnSite Silver Member
    Posts: 2,613

    Probably just a matter of drilling/bolting the plate up. Pics will help though.
     
  6. bradd

    bradd LawnSite Member
    Posts: 33

    is there any bolt holes?
     
  7. stumper1620

    stumper1620 LawnSite Bronze Member
    Posts: 1,889

    brade,
    take it over to Lesco, they are on Walkent dr. if you have never been there:
    they are located south off 3 mile just east of Fruit ridge in a new building on the west side of Walkent.
    I'm sure they can explain how it goes on. or call them at 616-791-8045
     
  8. bradd

    bradd LawnSite Member
    Posts: 33

    steve do u no where hillview lake is?
     

Share This Page