Injection Pump

Discussion in 'Irrigation' started by acolar, Sep 22, 2009.

  1. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Posts: 46,494

    I just wish I'd had my camera on the job way back when. I vividly recall one four-zone system that was controlled by the ubiquitious Intermatic 3-zone timer, with a relay attached to the case, that worked to turn it into a four-zone controller.

    [​IMG]
     
  2. MEXANDME

    MEXANDME LawnSite Senior Member
    Posts: 396

    Wet Boots suggestion is better but you could use a second timer for the 7 zones and wire it to the PSR for the pump only.

    Regards,

    Mex
     
  3. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Posts: 46,494

    You would still need at least one relay to isolate the two controllers both connected to the well's pump-start relay.
     
  4. MEXANDME

    MEXANDME LawnSite Senior Member
    Posts: 396

    Wet Boots....when I drew it out I did not see the need for the one relay but looking at it again....you are exactly right!!!

    Thanks for always being on top of things and for being willing to share your knowledge with us!!!!!!!

    Regards,

    Mex
     
  5. ARGOS

    ARGOS LawnSite Silver Member
    Posts: 2,808

    You are a god!
     
  6. AI Inc

    AI Inc LawnSite Fanatic
    Posts: 25,165

    No , Keep time set up on one of the clocks without the rid o rust setup.
    Have that clock run the pump while the other clock runs the rid o rust and opens the valves.
     

Share This Page