John Deere 111 pto clutch not engaging

Discussion in 'Mechanic and Repair' started by shopteacher, Jun 4, 2008.

  1. shopteacher

    shopteacher LawnSite Member
    Posts: 60

    Hello experts!
    I have a John Deere 111 Model #moo111h292131. I installed a used pto clutch for the deck. It worked fine, until I disengaged it and it wouldn't re-engage. I tested the switch and it tested ok.

    I have heard you can adjust them???? I also heard it will start again when cool. I don't want to buy a new one at over $250. Is there a simple cure?
    By the way, this model has the gas tank under the seat.
    Thanks in advance
     
  2. hdtvluvr

    hdtvluvr LawnSite Senior Member
    Posts: 490

    Hope this helps.

    John Deere 111 - Adjust PTO Clutch.jpg
     
  3. razor1

    razor1 LawnSite Bronze Member
    Posts: 1,985

    How long was it on before you disengaged? I had one that needed to cool before it would work again. Sometimes we'd give the spindle pulley a kick and it would engage.
     
  4. StevieZ

    StevieZ LawnSite Member
    Posts: 104

    Mine has fits if the battery voltage is too low.
     

Share This Page