1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Just another photo of a Fluid Film use:

Discussion in 'Eureka Fluid Film' started by 44DCNF, Apr 2, 2011.

  1. 44DCNF

    44DCNF LawnSite Bronze Member
    Posts: 1,459

    I purchased a cordless pole saw for a little touch up at a temporary residence. I am away from home and my saws. I did have the foresight to travel with my Fluid Film pump though.

    That's neither spicy brown mustard, nor caramel sauce in the oiling bottle on that scabbard.

    I did a quick search and didn't find anything. Have any of you used Fluid Film in lieu of bar and chain oil in a gas saw?

    photo.jpg
     
  2. SKYNYRD

    SKYNYRD LawnSite Fanatic
    Posts: 10,447

    honestly i have zero experience with using a chainsaw. i know it's not the same thing but i use ff on my table saw, chop saw, sawzall, drill bits and gas hedge trimmers, it keeps all those kinds of sharp edges and blades sharp, clean and lubricated so...

    i can't tell you what to do but i know if i did have a chain saw of any kind i wouldn't think twice about using ff on it
     
  3. RedSox4Life

    RedSox4Life LawnSite Bronze Member
    from Mass
    Posts: 1,409

    Bar oil is closer to motor oil. I sure wouldn't put FF in my crankcase.
     

Share This Page