Kohler 15Hp on Toro WB Bolt Specs HELP!!!

Discussion in 'Mechanic and Repair' started by MOW ED, May 26, 2002.

  1. MOW ED

    MOW ED LawnSite Fanatic
    Posts: 5,028

    I have a 15HP Kohler from 98 and it is on a Toro hydro WB. The bolt that holds the electric clutch has went away and I do not know what replaces it. I ordered one from Toro and they sent me a metric bolt which is supposed to work in there but no-way. Too small. Its a 8.8metric 1.5 thread #10. Part number matches the book but it ain't right.

    Can some one help me. The bolt is aprox 2 1/4". I am thinking mayby a 7/16. It starts to thread but is tight.
    Is it a 7/16 coarse, fine or something else. This is kickin my butt.

    Any help is greatly appreciated.
     
  2. smburgess

    smburgess LawnSite Senior Member
    Posts: 469

    Last week I replaced a 15hp Kohler on one of my walkbehinds and it had a label on it saying the shaft would one of two sizes, one was metric and one was 7/16 - 20 or 24. Sorry I can't remember the exact threads per inch. I hope this helps.
     

Share This Page