Kohler Command 22HP stalling out on hills?

Discussion in 'Mechanic and Repair' started by CharlieBingo, Apr 13, 2005.

  1. CharlieBingo

    CharlieBingo LawnSite Senior Member
    Posts: 400

    Any idea what this could be on level ground is fine, but on hills stalling out? :help:
  2. KathysLGC

    KathysLGC LawnSite Bronze Member
    Posts: 1,345

    Are the gas tanks full? How are the fuel lines? It could also be the float sticking and flooding the engine on hills.
  3. CharlieBingo

    CharlieBingo LawnSite Senior Member
    Posts: 400

  4. Travis Followell

    Travis Followell LawnSite Silver Member
    from KY
    Posts: 2,207

    Does it blow out any smoke when it stalls?

    I'd say its probibly a fuel problem If it blows black smoke when it stalls then its being flooded but if it doesn't smoke then i'd say its not getting enough fuel.
  5. rspruitt

    rspruitt LawnSite Member
    Posts: 1

    The Craftsman with a 19.5HP twin has the same problem. Any help would be appreciated.
  6. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,023

    Some Command Series engines have a sensor mounted along side the starter,If you go on too steep of incline it will intermitt the ignition system thus telling you it is unsafe.

    14yr. Kohler Factory Trained
  7. lrose2

    lrose2 LawnSite Member
    Posts: 165

    Some engines have a low oil sensor that is set off if the engine is a little low on oil and then placed on a hill thereby activating the sensor and shutting down the engine. Is the oil level OK?

Share This Page