Kubota Mini X Track

Discussion in 'Heavy Equipment & Pavement' started by Viseras lawn service, Jun 20, 2008.

  1. Viseras lawn service

    Viseras lawn service LawnSite Member
    from 6
    Posts: 217

    How does one go about removing slack in the rubber tracks on a kubota mini?
     
  2. coopers

    coopers LawnSite Bronze Member
    Posts: 1,224

    There should be a zerk fitting in the middle of each track that once you release it and pry the tracks together or something it will release the tension. It's been a while since I've done it so where exactly you hook with the bar I'm not 100% sure.
     
  3. Viseras lawn service

    Viseras lawn service LawnSite Member
    from 6
    Posts: 217

    there is a bolt in the center of the track assembly.....

    confused~~
     
  4. ksss

    ksss LawnSite Fanatic
    Posts: 7,129

    If your looking to tighten up the slack you should just have to add grease. On my TK there is small panel you remove on the side of the track and grease zerk is behind the panel. It is located on the track tunnel. Most all machines are similiar in this regard.
     
  5. coopers

    coopers LawnSite Bronze Member
    Posts: 1,224

    These two photos show where the zerk fitting is to expand or retract the tracks.

    ciop.JPG

    ciop 2.JPG
     

Share This Page