Lawn Striper

Discussion in 'Marketplace' started by tmarc, Jun 5, 2010.

  1. tmarc

    tmarc LawnSite Member
    Posts: 5

    I have a 36" lawn striper for sale. It is mounted on my 50" Cub Cadet RZT.

    I am asking $250.00. I can build these to fit any model.

    Thanks,

    Todd

    roller 1.jpg

    roller 2.jpg
     
  2. flatlander42

    flatlander42 LawnSite Silver Member
    Posts: 2,239

    when you hit a bump does that bracket smash into the muffler shield?
     
  3. tmarc

    tmarc LawnSite Member
    Posts: 5

    Hi,

    The pictures are about a week old and since then I have added about 3 inches to try to clear the muffler shield. My yard is mostly flat and I have not had any issues with it hitting. I'm still trying to tweek it a little to clear that shield without making it any longer.

    Thanks,

    Todd
     
  4. Glenn Lawn Care

    Glenn Lawn Care LawnSite Silver Member
    Posts: 2,647

    that is cool. does it strip good. i have have a roller on the deck so its not on the ground all the time.
     
  5. Jpeg lawn maintenance

    Jpeg lawn maintenance LawnSite Bronze Member
    Posts: 1,638

    I am interested would like to see some action shots if you have some ? see how it stripes.
     
  6. tmarc

    tmarc LawnSite Member
    Posts: 5

    When it stops raining here I will take some before and after shots. The last time I cut, I cut 1 inch shorter than I normaly cut and the stripes were not as defined as I wanted. It is supposed to be mounted at no more than a 45 degree angle and it was above that angle. I have since corrected that and will try different cutting heights to see where I need to be. Let me know if anyone has any advice.

    Thanks
     
  7. RDA

    RDA LawnSite Member
    Posts: 177

    What difference does the angle make, the rollers are round and roll on the ground regardless of the angle of the brackets.

    Regards,

    Rich
     
  8. tmarc

    tmarc LawnSite Member
    Posts: 5

    When It was mounted higher than a 45, even with stops on the upper bar, When I back up, it would try to ride under the mower. Now with it mounted lower than a 45 it corrected that problem.

    Thanks,

    Todd
     
  9. tmarc

    tmarc LawnSite Member
    Posts: 5

    Here is the front and side today after mowing.

    grass.jpg

    grass 1.jpg
     
  10. ygim

    ygim LawnSite Senior Member
    Posts: 300

    looks sweet.
     

Share This Page