Lawn Stripes

Discussion in 'Original Pictures Forum' started by JParisan, Jul 29, 2012.

  1. Blades Lawn Maintenance

    Blades Lawn Maintenance LawnSite Bronze Member
    Male, from Baton Rouge, La
    Posts: 1,233

    Yeah imma have to demo a exmark and see what's up with them
     
  2. SFS Landscaping

    SFS Landscaping LawnSite Member
    Posts: 5

    Can you post pictures of your striping kit when you get the chance?
     
  3. jbell36

    jbell36 LawnSite Bronze Member
    from KANSAS
    Posts: 1,283

    that's a good question...is it the striping kit that exmark offers, the roller that attaches to the deck? or is it an after market like Big League Lawns?
     
  4. JParisan

    JParisan LawnSite Member
    Posts: 52

    I use the standard Exmark kit installed on the rear of the deck.
     
  5. CFLS22

    CFLS22 LawnSite Member
    Posts: 163

    What setting is the striper set at? Because on mine I had it set low but when I would be on 3" it would make the deck bounce up whenever I would hit a bump so I moved it up one level and it just works ok now
     
  6. JParisan

    JParisan LawnSite Member
    Posts: 52

    What setting is it on(according to the diagram in the instructions) while you cut at 3"? I always have it around a 1/4 inch off the ground. So I'll have to adjust them from time to time. I never cut below 3.25. Usually 3.5 is my standard.
     
  7. CFLS22

    CFLS22 LawnSite Member
    Posts: 163

    I don't really remember I think I have the lowest bolt is on the 4th setting from bottom if that sounds right? 3.5 is also my standard and I hate going lower but there's always that one customer who thinks its too tall and makes me lower deck not allowing me to have the striker lower on the 3.5" lawns
    Posted via Mobile Device
     

Share This Page