Little dowel rod that holds elec.clutch in place.

Discussion in 'Mechanic and Repair' started by Reynolds & Son Lawn Care, Aug 28, 2009.

  1. Reynolds & Son Lawn Care

    Reynolds & Son Lawn Care LawnSite Member
    Posts: 2

    Can you replace that rod without taking the clutch off. I was wondering if the bolt would come out enough so I could pull that rod out and slip a new one in. I am working on a Kaw. engine on a Lazer Z. Thanks
     
  2. Reynolds & Son Lawn Care

    Reynolds & Son Lawn Care LawnSite Member
    Posts: 2

  3. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    There are eight different model Lazer Z's, I'm pretty sure your's isn't EFI so that leaves seven.

    Read this and comply so I can see what you are dealing with.
     
  4. ricky86

    ricky86 LawnSite Bronze Member
    Posts: 1,718

    You don't have to fully remove the clutch. Loosen the bolt and try to slid it back to gain clearance. It's tight but it can be done.
     

Share This Page