Longer Worktable Wanted

Discussion in 'Magna-Matic' started by CQ_DX, May 28, 2011.

  1. CQ_DX

    CQ_DX LawnSite Member
    from MA
    Posts: 67

    I, for one, am using the 9 inch worktable on the MAG-8000, but still wish it were longer.
    Given a chioice, I'd prefer it to be 2 inches longer on each side, for a total width of 13 inches.

    If the dimensions need to be governed by the sheet size the worktables are cut from, then the 13 inches could get longer (to prevent wasted scrap) and we users could trim them to desired length. Alternatively, if the 13 inch desired length is beyond that of the raw stock's sheet size, than any dimension which increases each end by at least an inch (11 inch overall length minimum) would be helpful.

    Is this a possible accessory?
     
  2. Magna-Matic

    Magna-Matic Sponsor
    Posts: 827

    Hi CQ_DX

    As i answered in your other thread - some new designs are in the works, and they'll be retro-fittable to previous generation MAG-8000s. We should be releasing them sometime this year yet, we're still doing testing of a few versions. But I will certainly pass all your comments to our engineers.

    Thank you for the suggestions!
     

Share This Page