Making a Striping Kit Using Rollers?

Discussion in 'Lawn Mowing' started by Chop Stuff Up, Oct 22, 2006.

  1. Chop Stuff Up

    Chop Stuff Up LawnSite Senior Member
    Posts: 457

    I've seen some homemade kits using chains and rubber flaps. I'm wondering if boat rollers would work... slide them onto some sort of shaft and weld them to a bracket and to the rear of the deck (48" WB). Think this would work, or is there a cheaper way? I guess I'd need 11-12 of them, I could probably find a cheap lot of them somewhere. What do you guys think?
     
  2. sawman65

    sawman65 LawnSite Senior Member
    Posts: 751

    simplicity's been doing it since the 50's
     
  3. prostriper

    prostriper LawnSite Senior Member
    Posts: 336

  4. Chop Stuff Up

    Chop Stuff Up LawnSite Senior Member
    Posts: 457

Share This Page