1. mowin at the lake

    mowin at the lake LawnSite Member
    Posts: 218

    I've got a problem with a 7 1/2 foot meyer.
    with the plow angled to the right or strait every thing is fine
    but when angled to the left the blade only touches the ground the first two feet on the right side
    while the left side is 2 inches off the ground....
    I assume some thing is bent
    I did notice that the A fram on the plow had a slight
    bend to one side.
    Any thoughts would be greatly appriciated.
     
  2. SlimJim Z71

    SlimJim Z71 LawnSite Senior Member
    Posts: 691

    I'm EXTREMELY tired... so if this sounds incredibly stupid, don't hold it against me.

    Is your cutting edge worn a little crooked???

    -Tim
     
  3. mowin at the lake

    mowin at the lake LawnSite Member
    Posts: 218

    it is a little and wasn't sure if that was it
     
  4. SlimJim Z71

    SlimJim Z71 LawnSite Senior Member
    Posts: 691

    Could be... there are a lot of factors involed with the angle your plow is on the ground at. The height of you plow mount, the angle of the A-frame, cutting edge wear... etc. That sounds like it could be your problem.

    -Tim[​IMG]
     
  5. GeoffDiamond

    GeoffDiamond LawnSite Bronze Member
    from Maine
    Posts: 1,651

    If the A-frame is bent that sounds like it could be your problem.

    Geoff
     
  6. KJ26

    KJ26 LawnSite Member
    from NY
    Posts: 18

    Yes your A-frame is bent. I had the same problem wensday nite. What i did for a quik fix was put the right side pin in the upper hole and the left side in the bottom hole. good luck and happy plowing. If you guys get bored,make the trip to Buffalo,,we've had 65 inches already and it's still coming.
     

Share This Page