Mix rate for Drive 75 DF

Discussion in 'Pesticide & Herbicide Application' started by Craig Turf Management, Apr 28, 2002.

  1. Craig Turf Management

    Craig Turf Management LawnSite Senior Member
    Posts: 354

    I will be spot spraying Drive from a backpack sprayer, and need help with the mixing instructions. The label states apply 0.367 oz of Drive 75 DF per 1000 square feet. I will be applying this product in conjunction with the Lesco sticker.

    1. How much product should I add to 4 gallons of water?
    2. Do I apply just to wet, or to the point of run-off?
    3.How do you measure 0.367 oz anyway? What type of measuring device do you use?

    I w2ill be applying this product to control crabgrass and other labeled weeds growing in established fescue.

    Thanks in advance for your help.
    Bill Craig!
     
  2. f350

    f350 Banned
    from mi
    Posts: 424

    when i applied drive i just barely misted over top the plant. to much and your destroy the surrounding areas's
     
  3. KirbysLawn

    KirbysLawn Millenium Member
    Posts: 3,486

    Bill....MSMA will give good results this early in the season at much less cost.
     
  4. Russo

    Russo LawnSite Senior Member
    Posts: 287

    How to calibrate 101

    1. Mark off a 1000 sq ft area ( I do this in gravel so I can see my coverage )

    2. WITH WATER ONLY, spray the area.
    -record how much water you used

    3. Calculate. If you used 4 gallons of water to treate 1000sqft. Then you need only .367 oz per back pack.
    If you used 2 gallons to treate 1000sqft, you'll need .734 oz per backpack.
    If you used 8 gallons to treate 1000sqft, you'll need only .184 per backpack.

    How much you mix per gallon depends on your RATE of APPLICATION for the SOLUTION. This product sounds like it is most effectively applied with a larger spray rig, but you should be ok if your treating a relatively small area.

    Apply the solution as if applying a good layer of paint. Don't miss any spots, but don't apply to the dripping point.

    Hey, BTW, these are things you learn in order to get your license.

    Can you guess the next question?

    Good Luck.
     
  5. Craig Turf Management

    Craig Turf Management LawnSite Senior Member
    Posts: 354

    Scraper, thanks for the lesson. I know how to calibrate my sprayers. My dilemma was when spot spraying crabgrass, ( which I have very little of in my lawns) I wouldn't use 4 gallons of spray for all of my properties. When I broadcast, I use my 100 gallon sprayer. I was concerned about over-concentrating, or under-concentrating my back-pack sprayer. How do you measure such tiny amounts of product? I really don't want to guess, but I don't have anything graduated in such small increments.

    Kirby, MSMA is what I have used in the past, and I will continue to use in my larger sprayer. Mr. Vaughn sold me the Drive last summer, and I have yet to use it. Just curious to see how it performs. It is high dollar!

    Scraper p.s. Yeah, I'm licensed. I hate applications though. In my opinion, it's much too easy to obtain a license in N.C. I'm really paranoid about screwing up a nice property. I'm reading a bunch, and asking lot's of questions. Trying to do it right.

    Thanks for all of the help. Bill Craig!
     
  6. Russo

    Russo LawnSite Senior Member
    Posts: 287

    Certainly didn't mean to offend you, Bill. Your question had a "joe home-owner" ring to it, so I gave you a "joe home-owner" answer. I'll try to be more considerate in the future.
     
  7. Craig Turf Management

    Craig Turf Management LawnSite Senior Member
    Posts: 354

    Scraper,
    Dude! You didn't offend me in any way. Thanks a bunch for your input.
    Take care, Bill Craig!
     
  8. HBFOXJr

    HBFOXJr LawnSite Bronze Member
    Posts: 1,712

    I'm not sure, but some products give the mix for hand held spot spray. I have info here but not at finger tips for Drive. It may??? be there if you read fully.
     
  9. KirbysLawn

    KirbysLawn Millenium Member
    Posts: 3,486

    Bill, if your sprayer is spraying 2 gallon per k you mix 1.5 oz per 4 gallons.
     
  10. Craig Turf Management

    Craig Turf Management LawnSite Senior Member
    Posts: 354

    Thanks Ray.
    Bill Craig
     

Share This Page