MP Rotator vs Single Stream Rotor

Discussion in 'Irrigation' started by txirrigation, Aug 6, 2011.

  1. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 22,073

    As they should be. :clapping:
     
  2. Kiril

    Kiril LawnSite Fanatic
    Posts: 18,308

  3. Mike Leary

    Mike Leary LawnSite Fanatic
    Posts: 22,073

    Finally! You learned your trade well, my son. :clapping:
     
  4. Kiril

    Kiril LawnSite Fanatic
    Posts: 18,308

    Yea ... and that is Type K copper on a brass swing joint.
     
  5. Wet_Boots

    Wet_Boots LawnSite Fanatic
    Posts: 48,027

    You mean that isn't threaded brass pipe? :p
     
  6. Kiril

    Kiril LawnSite Fanatic
    Posts: 18,308

    Not that one .... depends on the location and job. This one is a threaded brass pipe.

    DSCN2896.JPG
     
  7. txirrigation

    txirrigation LawnSite Senior Member
    from Texas
    Posts: 977

    Is that attached to the sprinkler main?

    We have to put a sign on it warning that it is not potable water in english and spanish.

    Then there is also the master valve regs that makes those things pointless.

    Nice job though, been a while since I have seen an irrigator actually use sch. 80 when going to brass like they should.
     
  8. Kiril

    Kiril LawnSite Fanatic
    Posts: 18,308

    Yes

    Thanks. All my manifolds and constant pressure mains are almost always SCH80 on residential lots. Any metal to plastic transition is always SCH80, and a male fitting unless there is no other way.
     
  9. txirrigation

    txirrigation LawnSite Senior Member
    from Texas
    Posts: 977

    Do you have to post a sign?
     
  10. AI Inc

    AI Inc LawnSite Fanatic
    Posts: 25,538

    " will plumb spigots for food"
     

Share This Page