My Painted Deck

Discussion in 'Original Pictures Forum' started by Gatewayuser, Jan 3, 2006.

  1. Gatewayuser

    Gatewayuser LawnSite Bronze Member
    Posts: 1,734

    As some of you might know I was painting my mower deck here is how it looks now. I wonder if I'm the 1st person to bondo a mower? Every part was taken off and cleaned or replaced.

    deck 1.jpg

    deck2.jpg

    deck3.jpg

    deck4.jpg
     
  2. South Florida Lawns

    South Florida Lawns LawnSite Platinum Member
    from usa
    Posts: 4,785

    That looks real good.

    I think if it were me I would have applied the do it your self bed liner, the good stuff.

    Although its expensive that stuff is hard to beat, completely stops rust and deadens noise.

    If I ever get time my new Z is getting the deck coated in that stuff.
     
  3. tiedeman

    tiedeman LawnSite Fanatic
    from earth
    Posts: 8,745

    that looks real sharp!!!
     
  4. 4x4Jim

    4x4Jim LawnSite Member
    Posts: 56

    Looks brand new. Good job!
     
  5. Dixie Rob

    Dixie Rob LawnSite Member
    Posts: 107

    Did you use a spray gun, or a spray can? You did better than I could do with either!
     
  6. nobagger

    nobagger LawnSite Gold Member
    from Pa
    Posts: 3,065

    Looks great! I wanted to do that to my older Exmark but I have zero time. Did you do the rest of the mower or is that the next project?:waving:
     
  7. tiedeman

    tiedeman LawnSite Fanatic
    from earth
    Posts: 8,745

    perhaps you need to think about painting professionally...or offer that as a service :)
     
  8. wriken

    wriken LawnSite Silver Member
    Posts: 2,154

    looks great
     
  9. lugnut#6

    lugnut#6 LawnSite Senior Member
    Posts: 404

    if i tried that there would be a bolt or two left over after i put it back together:confused:

    great work.
     
  10. Grn Mtn

    Grn Mtn LawnSite Senior Member
    Posts: 863

    No doubt me too on the missing bolts

    Hey my mower is next okay:p
     

Share This Page