need exmark help fast!

Discussion in 'Mechanic and Repair' started by mowingbtyard, Jun 4, 2009.

  1. mowingbtyard

    mowingbtyard LawnSite Member
    Posts: 32

    I have a new exmark laser with 46" deck. I was mowing some pretty tall grass today and shut mower off. when I went to start again the mower started but the blades wont engage when i pull the pto switch. Any ideas, I need help fast
     
  2. chesterlawn

    chesterlawn LawnSite Senior Member
    Posts: 703

    Did you check the fuse?
     
  3. 4.3mudder

    4.3mudder LawnSite Silver Member
    Posts: 2,227

    Sounds like the fuse
     
  4. JKOOPERS

    JKOOPERS LawnSite Bronze Member
    Posts: 1,259

    if its not your fuse check the battery. this is the main cause for the clutch not engaging.
     
  5. weeble67

    weeble67 LawnSite Senior Member
    Posts: 286

    I know it's ultra basic, but did you check that your blades aren't tied up and that the belt is in place?
     
  6. 4seasonsmgt

    4seasonsmgt LawnSite Member
    Posts: 5

    if all that fails there are 2 plug in switches in the back left hand side. I pulled mine out and greased and never happened again. Check you connections it hopefully is as simple as that.
     

Share This Page