Need some Meyer Info

Discussion in '<a href=http://www.plowsite.com target=_blank ?>Sn' started by MusGuy, Jan 31, 2001.

  1. MusGuy

    MusGuy LawnSite Member
    Posts: 41

    Does anyone have the diagrams for an E47 Pump, where the fill is on it, the drains... etc... I could help a friend... with it a lot different then my 60.....


    Appreciate it
     
  2. CMerLand

    CMerLand LawnSite Senior Member
    Posts: 393

    Mus,

    You can get a complete E-47 manual from Central Parts Warehouse for $ 5.00 which will show you the tear down and assembly of the pump. The quick answer for the E-47 drain is that it is the 3/4 inch bolt located immediately below the base of the "top can" (where the lift cylinder comes out.)

    The fill is located at the top of the can and has a small 7/16" vent bolt located on top of a larger 5/8" bolt. Pull off the vent and you can fill directly thru there.

    REMEMBER!!!!! THE LIFT CYLINDER MUST BE COMPLETELY PUSHED DOWN TO THE BOTTOM BEFORE FILLING WITH OIL!!!!!

    CMerLand
     
  3. Chuck Smith

    Chuck Smith LawnSite Senior Member
    Posts: 849

  4. MusGuy

    MusGuy LawnSite Member
    Posts: 41

    He has a leaky pivot and the part is on order... (small town and popular part)... on his angle rams coming in to it off the hydro line.... If I keep the resevoir filled for a while will that supply enough fluid to keep his plow going.. it is weak leak ... he maybe looses couple fluid ounces an event....
     
  5. Chuck Smith

    Chuck Smith LawnSite Senior Member
    Posts: 849

Share This Page