new gate lift assist....

Discussion in 'Trucks and Trailers' started by LawnScapers of Dayton, Mar 7, 2006.

  1. LawnScapers of Dayton

    LawnScapers of Dayton LawnSite Silver Member
    Male, from Dayton, OH
    Posts: 2,571

    I bought this trailer specifically because I liked the idea of being able to put a lift assist right in the top tube of the rail.....and the trailer was the right size and config.

    I just got the new lift assist installed. It has a 145# garage door spring inside the rail tube. The wheel is out of a 280 lbs. test pulley. Works great and take about 2/3 of the weight of the gate.....

    DSC02967.JPG

    DSC02968.JPG
     
  2. NEPSJay

    NEPSJay LawnSite Senior Member
    Posts: 492

    Looks Great!!! well done job. one of these days im gonna make one for my trailer. Good luck and Happy Mowing!!
     
  3. bugspit

    bugspit LawnSite Senior Member
    Posts: 769

    where did you get it?
     
  4. NEUSWEDE

    NEUSWEDE LawnSite Bronze Member
    from Maine
    Posts: 1,147

    I see springs on the hinges, those didn't work very well? Did you extend the gate at all?

    I ask becuase i am looking at a trailer with hinge springs and seems to handle it well.
     
  5. LawnScapers of Dayton

    LawnScapers of Dayton LawnSite Silver Member
    Male, from Dayton, OH
    Posts: 2,571

    I built in myself........the hinge spring...in my opinion was little more than worthless...... and no I didn't extend the gate...

    Derek
     
  6. bugspit

    bugspit LawnSite Senior Member
    Posts: 769

    Can you provide a full length shot?
     
  7. Lux Lawn

    Lux Lawn LawnSite Silver Member
    Posts: 2,267

    Looks good,its nice to have...it beats lifting that heavy gate all day.
     
  8. LawnScapers of Dayton

    LawnScapers of Dayton LawnSite Silver Member
    Male, from Dayton, OH
    Posts: 2,571

    I can but there really is not much else to see......there is 1- 3/8" bolt through the tube vertically that goes through the far end of the garage door spring, then on the gate side of the spring the cable is clamped to the other end of the spring with U clamps. The cable comes out of the tube over the pulley wheel and runs to the eye bolt on the gate. I placed the eye bolt at the level where the gate meets the rail tube... very simple......and really pretty safe since the spring is encased in steel and the bolts at each end will stop it if it were to break......

    I set it so there is no tension on the spring when the gate is up.

    I will try to get the full length shot today......


    D
     
  9. cochino12

    cochino12 LawnSite Senior Member
    Posts: 319

    Where can I find a pulley like that? I have all the rest of the pieces I need
     
  10. LawnScapers of Dayton

    LawnScapers of Dayton LawnSite Silver Member
    Male, from Dayton, OH
    Posts: 2,571

    It is a pulley from the rope and chain area at Lowes. I had to grind the pin that held the wheel, out of the pulley case, then discard the pulley case. Then I drilled the hole in the wheel out alittle to get the bolt through. I also found the silver spacers in the hardware area at lowes. There is one on either side of the wheel on the bolt.
     

Share This Page