New iron,Deere ct322

Discussion in 'Heavy Equipment & Pavement' started by minimax, May 8, 2008.

  1. minimax

    minimax LawnSite Senior Member
    Posts: 734

    Here are some pic of my new 322,with a cab,A/C,high flow,78" 4-in-1.
    Did the gold key tour and watched it be built.And yes have a bolt on edge comming for the bucket.
    DSCN1327.JPG

    DSCN1330.JPG

    DSCN1334.JPG

    DSCN1332.JPG

    minimax

    DSCN1327.JPG

    DSCN1330.JPG

    DSCN1334.JPG

    DSCN1332.JPG
     
  2. dozerman21

    dozerman21 LawnSite Bronze Member
    Posts: 1,170

    Looks good, congrats!:drinkup: What controls did you go with?
     
  3. JDSKIDSTEER

    JDSKIDSTEER LawnSite Bronze Member
    Posts: 1,163

    You will love it. I have started selling with the wide tracks as of late. Most here get a tooth bar instead of cutting edge. What are you running high flow?
     
  4. Construct'O

    Construct'O LawnSite Bronze Member
    from Sw Iowa
    Posts: 1,387

    New paint always looks good no matter what the machine is!!!!!! How did you like the gold key tour.It was at Dubuque,Iowa wasn't it?

    That was a great experience for me,something i will always remember.

    Is those the near tracks,because the wide are an option?Good luck with your new machine:drinkup::usflag:
     
  5. Tigerotor77W

    Tigerotor77W LawnSite Bronze Member
    from Germany
    Posts: 1,892

    Looks good!

    And boy do I miss the San Juans... oh man. The whole PNW, really. :(
     
  6. bobcat_ron

    bobcat_ron LawnSite Fanatic
    Posts: 10,119

    You can tell how low profile that bucket is when you got that much of the quick attach lips sticking up!

    But I do love the bolt on edge inside the bucket for the mold board, I wish I had that, it can get real costly to weld on a new edge!
     
  7. Bleed Green

    Bleed Green LawnSite Bronze Member
    Posts: 1,514

    I did not think you could get the wide tracks on the ct 322 jdskidsteer?
     
  8. bobcat_ron

    bobcat_ron LawnSite Fanatic
    Posts: 10,119

    You can, they already have the spacers built right in, but it's one hell of a wide ass machine, they are already 70" wide with narrow tracks, go with the wide tracks, and you are going to be another 6" wider.
     
  9. JDSKIDSTEER

    JDSKIDSTEER LawnSite Bronze Member
    Posts: 1,163

    Came out with in February. I have also replaced origionals with Solid Deal wide tracks.
     
  10. minimax

    minimax LawnSite Senior Member
    Posts: 734

    I went with the H patten hand controls.I did not get the wide tracks because the take the 4-in-1 off and put a 72" bucket and get into smaller places.
    The high flow is to run a flail mower and a stump grinder will get the mower later this year.

    minimax
     

Share This Page