1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

New Lazer Z Blade Height Question

Discussion in 'eXmark' started by robertbick, Jul 23, 2004.

  1. robertbick

    robertbick LawnSite Member
    Posts: 66

    My new Lazer Z 27HP Kohler 60" deck was delivered yesterday. I have a question regarding blade height. It is sitting in my garage right now on a level concrete floor and I set the cutting height at the 3" setting. I measured the blade tips from the ground and they measure 4".

    Is there an easy way to adjust it so the blade height matches the setting?

    I know I could set the deck at 2" to get a 3" cut but I am a picky person.

    I also measured the deck rake and that is set just right. Any help is appreciated.

  2. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258


    Please let the dealer know ASAP. The cutting height should be accurate. If the deck is off that much we need to have it looked at and make sure it is corrected.



Share This Page