New Toro g3 striping kit problem

Discussion in 'Lawn Mowing Equipment' started by cps, Jul 31, 2013.

  1. cps

    cps LawnSite Member
    Posts: 109

    Just picked up a new toro 60" z master 6000 seres and added the roller striping kit. Even before we installed the roller (one size for 48-60") we could tell it was too short. Once on you can see a 2" gap between the edge of the roller and the tire. It leaves a trail of grass up in your stripes! Not the best lawn to test it but you get the point. You can see it her in the pic, the left side of the stripe....
    :dizzy:

    Has anyone else had this problem?

    Toro why don't you offer the correct size for each size of deck?!?!?!

    image.jpg
     
  2. cps

    cps LawnSite Member
    Posts: 109

    I know I'm not the only one...
     
  3. cps

    cps LawnSite Member
    Posts: 109

    Bump with another pic

    image.jpg
     
  4. catpride22

    catpride22 LawnSite Member
    Posts: 93

    The toro deck sits so close to the rear tire you cant get the striper any wider such as on a exmark,you can get a striper for a scag which mounts to the rear of the mower or secure a piece of rubber on the rear edge of the deck to get rid of that 2 inch void between the striper and tire,i also have the same problem with my toro,but have not yet fixed it.and there stripers are not one size fits all,they are specific to deck size and model.
     
  5. cps

    cps LawnSite Member
    Posts: 109

    For the turbo force deck I was told by my dealer that it was the same kit for a 48"-60", they do make a larger kit for the 72" deck.

    I was looking at the scag kit but was told the the bagger would be in the way?
     
  6. catpride22

    catpride22 LawnSite Member
    Posts: 93

    Cant see my striper fitting on a 48" deck.if so then the 72" striper should fit on a 60".
     

Share This Page