1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Onan Ignition Module - Gone Bad?

Discussion in 'Tractors' started by 1966vette, May 30, 2010.

  1. 1966vette

    1966vette LawnSite Member
    Posts: 203

    I'm having problems w/ my 16hP Onan Wheelhorse 616-Z ZTR.
    The engine runs fine when cold but shuts off when it gets hot.
    I already replaced the coil because it tested defective but the cutoff problem still exists.
    I ran 12 volts to the + side of the coil & still no spark. This indicates that the oil pressure sending until is not the problem.

    I'm looking for any tips that maybe helpful when I remove the blower housing cover & flywheel.

    I'm also in the market for an ignition module for the Onan P216V / 10873A engine.

    Thanks!
    Andy
     

Share This Page