1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Percent Mark Up!!

Discussion in 'Irrigation' started by eazy, May 22, 2004.

  1. eazy

    eazy LawnSite Member
    from Texas
    Posts: 51

    If at all, what percent do you mark up appliances (pipe, heads, timers and so on) for a sprinkler installation after you get them from the dealer?


    Thanks for your time,
    eazy
     
  2. houston

    houston LawnSite Member
    Posts: 71

    Are you getting a discount at the dealer or paying "retail" like a homeowner would that walked in and wanted something?

    If you are getting a "REAL GOOD" discount from the dealer then anywhere between 30-60% should be good for a full system install. If it were just a small amount like a piece of pipe and a head or two and a few fittings I might charge retail price. For a complete install 30-60% depending on how large of a project it is.

    :waving:
     
  3. DowntoEarthLLC

    DowntoEarthLLC LawnSite Member
    from VA
    Posts: 121

    so do you markup each individual part or do you just mark up the total cost?
     
  4. houston

    houston LawnSite Member
    Posts: 71

    DowntoEarthLLC,

    Just total up the materials used and mark that total up. Don't itemize the bill. Just put down:

    1. Labor - $xxx
    3. Material (including markup) - $xxx
    ----------------------
    Total: $xxx

    payup
     

Share This Page