Pics of the new setup.

Discussion in 'Pesticide & Herbicide Application' started by jackedf150, Mar 24, 2011.

  1. jackedf150

    jackedf150 LawnSite Senior Member
    from Indiana
    Posts: 416

    31, If you go to the first page there are pics of the pump. Its is wired into the trailer plug.
     
  2. Falcon50EX

    Falcon50EX LawnSite Senior Member
    from GA
    Posts: 999

    Truck wheels look good now get out and make some money.
     
  3. jackedf150

    jackedf150 LawnSite Senior Member
    from Indiana
    Posts: 416

    Well finally have gotten use to the z-spray. Must say I really like it. Now just waitin for my dandelions to die!

    Home.jpg
     
  4. MACtheFERTman

    MACtheFERTman LawnSite Member
    Posts: 17

    Does anyone know of a site where i can get plans to hook up a 300 gallon spray tank with all neccesary equipement i.e. pump, motor and reel. I am going to utilize a spare open trailer I have. I am doing this so my lawn guys can use spare truck if necessary...knock on wood. It needs not to be a permanent setup. I have been combing this site literally for hours trying to find a correct forum to post this in thsi is the closest I've gotten.
     
  5. humble1

    humble1 LawnSite Silver Member
    from MA
    Posts: 2,495

    Gresonclark for the pump motor and hose if you have the tank. Make sure you put a filter screen on the suction end and psi dump valve
    Posted via Mobile Device
     
  6. Shades of Green LService

    Shades of Green LService LawnSite Bronze Member
    Posts: 1,011

    Anyone else have pics of there enclosed trailer set up?
     
  7. Laner

    Laner LawnSite Senior Member
    Posts: 323

    I am looking for pics of enclosed trailer spray/fert setups as well. I have some ideas, but looking for additional ideas on what has worked/not worked for others as well. I have a skid sprayer that I would like to be able to use in the trailer also, just not sure on how I want to mount the hose reel to get the hose outside the trailer door and not rubbing on the edges of the door when pulling at an angle. And I still want to be able to use the side door to load fert/chem/supplies in front of trailer.
     
  8. RigglePLC

    RigglePLC LawnSite Fanatic
    Posts: 11,785

    YOu may need to put smooth plastic near the door edges or rollers to keep the hose from rubbing. Hannay offers a roller kit that might meet your needs. Chrome rollers so you can pull the hose at an angle.
    http://www.hannay.com/PDF/oa.pdf?IDENT=141

    Be alert for the problems of engine exhaust and excess heat buld up in the trailer.
     
  9. BLC1

    BLC1 LawnSite Senior Member
    from Ohio
    Posts: 714

    What are you doing to power the pump?
     
  10. Laner

    Laner LawnSite Senior Member
    Posts: 323

    The pump on the skid is powered by a gas engine. The pump for the nurse tank is powered by an electric pump, that is connected to a marine battery. Which is connected to the trailer wiring to truck plug to charge the battery when running.
    Posted via Mobile Device
     

Share This Page