Separate names with a comma.
Missed the live Ask the Expert event?
Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .
Discussion in 'Mechanic and Repair' started by jobjonnie, Mar 26, 2006.
Forgot to ask at the store what the gap is. Is for 18hp brigs intek.
Sure do it's .020"
ok, so which is it??? .020" sounds awfully tight for that size of an engine. .020" is what my small 2 stroke stuff runs at...
My Intek Service Manual states .030 for ALL horizontal crankshaft models or .020" for ALL vertical crankshaft models......
OK Guys, My bad. I grabbed up my small block manual, newz7151 is correct on the large block engines being .030