Pto Switch

Discussion in 'eXmark' started by Columbia Turf, Jun 6, 2001.

  1. Columbia Turf

    Columbia Turf LawnSite Member
    Posts: 99

    I love the new pull type PTO switch on the new models. My question is, Is the wiring harnes the same on the models with the toggle switch? When the toggles break again, (have before), Can I take the hole in the dash, make it a rectangle and use the new pull type switch. The units I refer to are 1960TT's serial #190000 and up(I think)

    Thank You
    Tom Boland
    Columbia Turf
     
  2. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    Columbia Turf,

    Thanks for taking the time to write in with your question, I had to look that up myself to be sure. The wiring harness is the same, except for the connector. If you got the correct connector, cut out the hole, and get the new switch it would work fine.
    Email me at service@exmark.com and I can get you a copy of the wire harness so you know how to route the wires into the new connector.
    I hope this helps. Again, if you have any questions, don't hesitate to contact us at service@exmark.com

    Thanks,
    Lenny
     

Share This Page