QDS Bagger w/ROPS retrofit

Discussion in 'eXmark' started by Potchkins, Nov 21, 2006.

  1. Potchkins

    Potchkins LawnSite Senior Member
    Posts: 570

    i have a pre 440,000 lazer z 2003 model
    QDS mod#LZUVD60 ser#390037

    the bracket for the quick dump arm was a four bolt bracket had to be taken off when the ROPS was installed. I need a part number for the three bolt version. That won't interfere with the ROPS.
     
  2. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    Hello Potchkins,
    Thanks for writing in. Mounting 'mixed serial unit' Ultra Vacs can get a little confusing. You're going to need a handle kit, (P# 103-6254) to get that to work properly.

    I hope this helps. Let me know if you have any questions.

    Thanks,

    Lenny
     
  3. Potchkins

    Potchkins LawnSite Senior Member
    Posts: 570

    both units were bought new 6-03
    the bagger worked fine on this unit until this summer,
    this problem is a result of adding the ROPS system
    what is included in the "handle KIT"? and how much $ ?
     
  4. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    Hello,
    You get a handle and mount assembly with the 103-6254. Please visit with your Dealer for exact pricing information.
    Thanks,
    Brian
     
  5. Potchkins

    Potchkins LawnSite Senior Member
    Posts: 570

    all i need is the mount, i still got everything i took off
     
  6. Potchkins

    Potchkins LawnSite Senior Member
    Posts: 570

    can i get i part number for just the mount?
     
  7. eXmark

    eXmark Manufacturer / Sponsor
    Posts: 4,258

    Yes, I think it is a 103-5615-03, Handle Mount.
    Brian
     
  8. Potchkins

    Potchkins LawnSite Senior Member
    Posts: 570

    thanks for all yall's help for future reference the kit is required, because the new bracket is clocked different, the new handle is built different than the original to work with the different bracket and the kit is priced very reasonable
     

Share This Page