Ransomes Bobcat 48 WB Belt Issue

Discussion in 'Mechanic and Repair' started by JohnnyRocker, Apr 13, 2010.

  1. JohnnyRocker

    JohnnyRocker LawnSite Senior Member
    Posts: 739

    My bobcat(48) belt wb stopped a couple times while heading up hill, the engine ran fine, but it didn't move. It was wet at first, so I figured that may be the cause. But after my 3rd lawn, I figured everything was dry, but it did it again going up my rampgate. Do you think it was still wet, or something else? Any advice would be great. It's a 930010 model if that helps any, I think it's from 1997. Not sure about that though. Thanks.
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    Look at the condition/tension on the drive belt from engine to transmission, Replace/adjust as nessassary......
     
  3. JohnnyRocker

    JohnnyRocker LawnSite Senior Member
    Posts: 739

    Thanks. I'll do that.
     

Share This Page