1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community on the Franchising Forum.

    Dismiss Notice

Removing Carb Nozzle

Discussion in 'Mechanic and Repair' started by hdtvluvr, May 12, 2007.

  1. hdtvluvr

    hdtvluvr LawnSite Senior Member
    Posts: 466

    I'm rebuilding the carb now on a 11 HP B&S engine (252707). I can not seem to get the nozzle out. The screwdriver is slipping and damaging the brass. Do I need an eze-out?

    Thanks in advance.
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    The holes in that nozzle are so large it's not necessary to remove it, Just leave it in and shoot carb & choke spray cleaner with the straw through it and re-assemble.

    BTW, I have found those 4/6 in one screw drivers from the hardware store works great for removing jets without damaging the internal threads.
     
  3. hdtvluvr

    hdtvluvr LawnSite Senior Member
    Posts: 466

    Thanks, I did spray it very good and then realized a new one came in the kit. That's when I decided to just replace it while I was there. I'll leave the old one in.

    Thanks
     

Share This Page