Scag engine help please

Discussion in 'Tractors' started by samara21, Sep 16, 2004.

  1. samara21

    samara21 LawnSite Member
    Posts: 1

    Hi, I bought a used and abused Scag SSZ-48 for a project. It has a blown Briggs Vanguard 18 on it now, and over the winter I was going to restore it back to Kohler only bumping it up to a 20hp. My problem is, what are the specs of the factory motor, ie: shaft diameter and length. The briggs has a 1" X 3 5/32" shaft. Is that right?

    thanks
    sam
     
  2. Travis Followell

    Travis Followell LawnSite Silver Member
    from KY
    Posts: 2,207

    If the mower came out with a 20 hp Kohler engine then you should have no problem putting that engine back on it. I don't know the shaft specs on that engine but you should get that engine to fit on the mower without a problem.
     
  3. Green Care

    Green Care LawnSite Senior Member
    Posts: 530

Share This Page