I recently replaced my scag engine (thanks RestroRob for the wiring diagram) I put a FH500V 17hp AS15 on it to replace the old FH500V. I "upgraded" to a electric start and now I am stumped on how to wire the electic clutch..... The old one had the connector for the clutch coming out of the engine and you would just plug it in. The new one doesnt have it. I contacted SCAG and they had asked me to give them the serial numbers and all that jazz and said I have to switch it over to a pull start. So I sent them everything I had and they have yet to respond to me. Its been 3 weeks now. My first email got replied in hours. Now nothing. So they are leaving me hanging here. Its a Scag Model SW248A, 5170452 Anyone know how to go about this? How can I hook up my electrical clutch now? I have the clutch plugged in but there are 2 more wires ( one looks white and the other is a faded yellow) coming of the old engine with the harness. I only have the black and green coming out of mine, besides the magneto wires that harness up to the volt.reg. Thanks in advance!!!!!