sentar hydro belt

Discussion in 'Lawn Mowing' started by rmland, Apr 29, 2007.

  1. rmland

    rmland LawnSite Member
    Posts: 57

    hey folks
    i just lost my wright sentar hydro belt, any one changed these out? do you jack the machine up or tear some pates off thanks for any help
     
  2. ed2hess

    ed2hess LawnSite Fanatic
    Posts: 13,320

    Yep you are in for a good little cursing secession......Long story short I tried to replace it but had to take it to the dealer. It is very difficult to get to the bolt that holds the clutch in place and it has to be removed. You need a special swivel on the end of air wrench between the air wrench and the socket and the socket needed to be very thin walled. The swivel device is a common tool but I didn't have it.

    To get under it I drove it out onto one of my two gates on the trailer that I had blocked up to be flat with the trailer bed. I removed the other gate..so essentially it was up off the ground so I could see everything. Getting the clutch wires disconnected was a little tricky. Definitely an area that could be improved. It looks like the belt won't make a full year either.
     

Share This Page