Snapper Help

Discussion in 'Mechanic and Repair' started by Speedysnapper, May 16, 2009.

  1. Speedysnapper

    Speedysnapper LawnSite Member
    Posts: 2

    Hi first post here after doing some research on these forms I just bought a new 21 inch Snapper Commercial Hi-Vac Kawasaki mower . I also bought the ninja mulching kit ( not the plug ) my question is can I unbolt the recoil and turn it so the rope will exit from the back . As when I remover the bagging system it also removes the little wheel that holds the rope out so now the rope comes out on a terrible angle making it almost impossible to pull over . Any advice would be great , Thanks
     
  2. Restrorob

    Restrorob LawnSite Fanatic
    Posts: 11,024

    If you have the FJ180 engine it looks like it may be possible, Just remove the four screws and give it a try......
     
  3. Speedysnapper

    Speedysnapper LawnSite Member
    Posts: 2

    Thanks I'll give it a try just thought I'd ask as someone must of went from a Hi-Vac to a mulcher and came across the same problem . If it don't work I'll have to buy a recoil from the mulch model where the rope does exit from the rear .
     

Share This Page