Snapper Keez Power rake questions

Discussion in 'Lawn Mowing Equipment' started by Watkins, Apr 19, 2011.

  1. Watkins

    Watkins LawnSite Member
    Posts: 107

    I recently puchased a snapper keez ? power rake / thatcher.
    I have it in the shop right now and I had to have the rods for the blades made as they were not available anywhere I looked.

    After the new blades were installed and a new belt and the rods were added the thatcher was ran for about 2 mins and the bearings that are located within the thatcher failed and the thatcher began to go off balance and vibration occured.

    Where in the internet world could I find these bearings ?

    I asked him if they were a .056
     
  2. Watkins

    Watkins LawnSite Member
    Posts: 107

    Bump.
    Still looking.

    Thanks,
    I also need new blades, they are flat and about 3 inches or so long by about 1 inch wide.
     
  3. kawakx125

    kawakx125 LawnSite Bronze Member
    Posts: 1,120

    just measure the bearing and reference it to a chart
     

Share This Page