I've just purchased a used Snapper Pro 48 (hydro) and it pulls the right a little bit if I realease both levers completely. Also, I've noticed that when turning or stopping the right lever isn't as "responsive" as the left lever. Meaning if at a dead stop, I have to pull the right lever back further to keep it in a straight path backwards. Same for going forward; I have to let the right out further to keep up with the left side. I was just wondering if anyone has had this problem on a similar Snapper or other mower. There is a rod that goes to the hydro system for each lever, but the tinkering I've done with adjusting it has not gotten me anywhere. Wondering if I need to keep messing with that or if I should be looking into the hydro system... thanks for the help!