1. Missed the live Ask the Expert event?
    Not to worry. Check out the archived thread of the Q&A with Ken Hutcheson, President of U.S. Lawns, and the LawnSite community in the Franchising forum .

    Dismiss Notice

spindle Assembly 580-d toro mower

Discussion in 'Lawn Mowing' started by raider450, Apr 21, 2009.

  1. raider450

    raider450 LawnSite Member
    Posts: 1

    Ok! I replace the spindle assembly,because spindle shaft and pulley spindle strip at the splines(what causes this?)so I replace shaft,pulley bearings,seals pack the bearings.A week later toro returns with same problem.The only thing that I could think is that I did not install the spacer between bearing (lower blade side)and I notice when I was greasing no grease would go in the spindle assembly.Is there a preload on this assembly and how much?(little or no play)Thanks!

Share This Page