Sprinkler Design Software

Discussion in 'Irrigation' started by Luke Kindle, May 22, 2008.

  1. Luke Kindle

    Luke Kindle LawnSite Member
    Posts: 15

    What are you all using for a sprinkler design software? Is there a downloadable one?
     
  2. Bruiser

    Bruiser LawnSite Member
    Posts: 73

    I use RainCad.
     
  3. Luke Kindle

    Luke Kindle LawnSite Member
    Posts: 15

    Is it easy to use? How much is it?
     
  4. Lawnrain

    Lawnrain LawnSite Member
    Posts: 11

    I use Raincad as well. Its seems to work very well for us. It can cost you some money though...If I remember right I think if was about 2000.00 to 3000.00, plus you need a design engine to run it with....like Autocad....2000.00 to 5000.00 depending on what version you get.....Its a great investment though...
     
  5. EagleLandscape

    EagleLandscape LawnSite Platinum Member
    Male, from Garland, Texas
    Posts: 4,347

    AutoCAD...........
     
  6. No Rush

    No Rush LawnSite Member
    Posts: 203

  7. DanaMac

    DanaMac LawnSite Fanatic
    Posts: 13,156

    Pencil
    Graph paper
    Ruler
    = real cheap
    :laugh::laugh::laugh:
     
  8. AI Inc

    AI Inc LawnSite Fanatic
    Posts: 25,525

    My brain and my eyes. Pen dosnt hit paper till the job is done.
     
  9. Waterit

    Waterit LawnSite Silver Member
    Posts: 2,906

    Same here - and then just 2 pieces of paper, my invoice and their check.
     
  10. AI Inc

    AI Inc LawnSite Fanatic
    Posts: 25,525

    I do an as built for all. simple handheld 10 minute scetch. Then gets scanned into pc and printed and stapled to service orders later.
     

Share This Page