Starter seal coating unit

Discussion in 'Seal Coating Forum' started by joeE, Jan 2, 2006.

  1. joeE

    joeE LawnSite Senior Member
    Posts: 273

    I have a small system that i dont need.

    150 gal low profile tank. Hand crank full sweep agi with rubber wipers. Arms
    are cut & pinned & spring loaded ( bend at top & bottom of stroke, fully extend at sides). Tank is older but clean & used very little.

    Brand new Ingersol Rand compressor & Graco duel dia pump. I started putting this system together last year for my son. Hes now working for a
    cement contractor so I dont see any need to keep it. The only thing left
    is to add a 50' hose & wand. This will make someone a good tool for many years.
    $ 1,795.00 firm. NW lower MI

    joeE

    equipment 020.jpg
     
  2. joeE

    joeE LawnSite Senior Member
    Posts: 273

  3. joeE

    joeE LawnSite Senior Member
    Posts: 273

    For $ 700 extra, I could swap out the 150 gal tank with a 300 gal. Hand crank, 5 to 1 reduction, close clearance steel, 1 1/2" shaft, 4 bolt bearings, 2" outlet. Older tank in good cond.

    Copy of equipment 004_edited.jpg
     
  4. joeE

    joeE LawnSite Senior Member
    Posts: 273

    Many thanks to LawnSite.com

    All has been sold.
     

Share This Page